[Elecraft] Tiltup Stand

[Don Brown]

Hi

Here is the method I use. Install the front screws only and leave them lo=
ose. Push the stand into the two holes compressing the stand and rotating=
 the feet a little. Once the stand is in place use pliers to rotate the f=
oot so the back screw will drop through the hole in the panel. Install th=
e washers and nuts and tighten all of the screws.

Don Brown
KD5NDB

----- Original Message -----
From: Roy Vickers
Sent: Friday, October 18, 2002 12:23 PM
To: elecraft@mailman.qth.net
Subject: [Elecraft] Tiltup Stand

Hi,
First post and I hope it works!
I tried to install the tiltup stand on my K2 last nite but I couldn't get
the stand compressed enough to fit it in the mounting pads. I tried
installing one pad, installing the stand and then I couldn't get the stan=
d
compressed enough to mount the second pad. Anyone have any ideas?
Thanks
Roy Vickers

_______________________________________________
Elecraft mailing list: Elecraft@mailman.qth.net
You must be a list member to post to the list. =20
Postings must be plain text (no HTML or attachments). =20
See: http://mailman.qth.net/mailman/listinfo/elecraft
Elecraft Web Page: http://www.elecraft.com


--- StripMime Report -- processed MIME parts ---
multipart/alternative
  text/plain (text body -- kept)
  text/html
The reason this message is shown is because the post was in HTML
or had an attachment. Attachments are not allowed.
Please post in Plain-Text only.---