[Elecraft] KAT100 LED assembly

[Tom Hammond NØSS]

Vic:

I noticed this, BUT with only a SMALL amount of 'urging' I was able to get 
them to pass thru the holes with little, if any, complaint.

Carefully PULL the leads... DON'T PUSH them.

Tom

At 01:20 PM 11/11/02, Vic Rosenthal wrote:
>The KAT100 manual says the front-panel LEDs must be flat against the 
>board.  The leads of the LEDs have little crimps that stop them from being 
>inserted all the way.  Is the manual correct and I should force them in 
>all the way (or file the crimps), or should I just go as far as the crimp?
>
>I think they need to go in all the way, but I just want to be sure.