FW: [Elecraft] KIO2 Aux I/O

Sun May 19 13:36:00 2002

Thanks Dan, it appears that I have a male in place of one of the female 
'D's.  The pins/sockets I referred to below were on the connector side 
rather than the PC board.  No great problem, I can source one locally
(my junk box!)

Trev G3ZYY

In message <[email protected]>, Dan 
Barker <[email protected]> writes
>Use the female on the board. The other two are for the cable. 
>Hopefully, the additional female will show up before you need the cable 
>for testing. Have you asked for a replacement yet? RS will have 
>something which will do, but the covers might not match.
>
>btw, both M and F connectors both have pins on the cable (or pc board) 
>side. The M has pins on both sides.
>
>Dan / WG4S / K2 #2456
>
>-----Original Message-----
>From: [email protected]
>[mailto:[email protected]]On Behalf Of Trevor Day
>Sent: Sunday, May 19, 2002 7:40 AM
>To: [email protected]
>Subject: [Elecraft] KIO2 Aux I/O
>
>
>
>Hi Guys,
>
>Just doing the inventory of parts for the various options and I'm a
>little confused by the description in the inventory list for the KIO2.
>The list indicates x2,  9 pin female 'D' connectors and x1, 9 pin male
>connector. This may be just semantics, but my kit contains 2 connectors
>with 9 pins, and 1 connector with 9 sockets.  To my mind thats 2 male
>and one female!
>
>Either way, can someone tell me if I have the right components?
>
>Thanks, Trev G3ZYY
>2637
>

-- 
Trevor Day