[Elecraft] K2#2032-revision B, Feb.14,2000

[Bruce Rattray]

I am installing the ATU in the top cover...

-page 16 -

-instruction-Connect the ATU RF cable (J7) to the K2 RF board at P6 (AUX
RF). The notch in J7's connector housing must grip the locking tab of P6.
BOTH THE LOCKING TAB AND NOTCH SHOULD FACE THE K2 FRONT PANEL.

...the problem...I installed P6 with the locking tab facing the REAR
panel...I remember pondering on how this connector goes in but I guess I
"pondered wrong."...I think I went by the outline on the board...

...I would rather not have to disassemble the heat sink, finals, etc
in order to turn P6 around to face the front panel, but if I have to, I
have to...

...instead, can I reverse the RG-174 leads on the female connector that
plugs into P6?...thank you oh K2 gurus...

..72/73 - Bruce (VE5RC+VE5QRP) QRP-C#1  QRP-L#886  ARCI#9683  Zombie#272
            A-1 Operator Club - 10/10# 944 - QRP Borg#1  - Whiner#10 -
            - VE5QRP SOC#11 - VE5RC SOC#12 - oo#148 - K2#2032 - COG#15 -
          "QRP! How sweet it is!"        "I am da man wit "DAH" paddle!"