[Elecraft] Building K2 with options in mind

[Kevin Cozens]

At 06:59 PM 03/19/2002 -0600, George Talia wrote:
>If I build the RF board with the parts installed on it that are needed for 
>the SSB adaptor will it affect the results of the check out and alignment 
>steps for the base K2?  Or should I just build the base K2, check it out 
>and align it, then remove and/or add the parts required by the SSB board?

You won't be able to test the base K2 without the KSB2 installed if you 
don't install the jumpers and capacitor that you will be asked to remove 
when you install the KSB2. You would be better off building the base K2 as 
described in the manual. Once you know it is working properly then you can 
deal with installing the K2 and the changes that are required.


Cheers!

Kevin.  (http://www.interlog.com/~kcozens/)

Owner of Elecraft K2 #2172        |"What are we going to do today, Borg?"
E-mail:kcozens at interlog dot com|"Same thing we always do, Pinkutus:
Packet:ve3syb@ve3yra.#con.on.ca.na|  Try to assimilate the world!"
#include <disclaimer/favourite>   |              -Pinkutus & the Borg