[Elecraft] K2 Power Output

[Drqrp@aol.com]

On two isolated occasions I have noticed that I have no indication of power 
output on the bargraph (both time at 5 watts).  Turning the power knob from 5 
watts and then back to 5 watts remedies the problem.  Both times this 
happened immediately after switching from the 'practice' mode to the 'oper' 
mode on cw.  I run directly to a resonant dipole so I had no indication of 
whether there was actually no rf or if it is just a problem in the sensing.  
Anyone else experienced this problem? 72-Randy,wv9n