[Elecraft] K1 #690: No power out on TX

Sun Mar 3 16:20:01 2002

Hi Bob:

I had this problem until I really 'scorched' in the leads to those toroids.
The enamel is just plain hard to completely get rid of and when you pull the
leads taught you find that you didn't remove enough enamel - get close
enough to the toroid. Also check full rotation of those slugs - it will
surprise you when the last slug finally makes the power go up ;)

Jamie
WB4YDL

-----Original Message-----
From: [email protected]
[mailto:[email protected]]On Behalf Of [email protected]
Sent: Sunday, March 03, 2002 2:35 PM
To: [email protected]
Subject: [Elecraft] K1 #690: No power out on TX

Well, I guess in spite of being careful and triple-checking
everything, I have run into a problem.  When I started the
"Alignment and Test, Part II", I was unable to get any
power out of the K1.  I'm using the KFL1-4 4-band module.
The LCD display constantly indicates "P0.1".  Adjusting the
trimmers has no effect on any band.

- The maximum output power is set o 2.0 watts.
- The voltage checks on page 46 are all perfect.
- I verified all components were properly installed.
- The toroids were wound properly, stripped and tinned.
- Nothing is getting hot or smelly (sniff test passed)
- I went over virtually every solder joint in the transmitter
  section and touched them up, even though they all
  looked good.
- The keyer seems to work; that is, I get a sidetone.

Any suggestions?

Thanks and 73,

Bob  WA4FOM

--- StripMime Report -- processed MIME parts ---
multipart/alternative
  text/plain (text body -- kept)
  text/html
---
_______________________________________________
Elecraft mailing list: [email protected]
You must be a list member to post to the list.
Postings must be plain text (no HTML or attachments).
See: http://mailman.qth.net/mailman/listinfo/elecraft
Elecraft Web Page: http://www.elecraft.com