[Elecraft] Frequency calibration

Thu Jun 20 12:17:00 2002

Sounds simple enough :)   
    Thank you,
        Kevin.


6/20/2002 10:05:07 AM, "Don Brown" <[email protected]> wrote:

>Hi
>
>I set up a marker at 500 and 600 Hz in Spectrogram. Then adjust the k2 so the WWV 500 and 600 Hz tones are 
centered on the markers. The markers are on most alternate minutes. Then read the K2 display and see how much it 
is off. Adjust the 4 MHZ master clock on the control board by the same amount as the error as described in the 
manual. Then do the PLL calibration and recheck WWV with Spectrogram. You may have to do this procedure 
several times to get it perfect.
>
>Don Brown
>KD5NDB
>
>----- Original Message -----
>From: [email protected]
>Sent: Thursday, June 20, 2002 10:53 AM
>To: [email protected]
>Subject: [Elecraft] Frequency calibration
>
>Howdy group,
>   Does anyone have a procedure written up for calibrating the frequency on the K2 using Spectrogram?  I have 
used this
>software to tune my CW and SSB filters but I would like to use it to get my K2's frequency readings a little closer to 
what
>they should read.
>   Kevin.
>
>
>_______________________________________________
>Elecraft mailing list: [email protected]
>You must be a list member to post to the list.
>Postings must be plain text (no HTML or attachments).
>See: http://mailman.qth.net/mailman/listinfo/elecraft
>Elecraft Web Page: http://www.elecraft.com
>
>
>--- StripMime Report -- processed MIME parts ---
>multipart/alternative
>  text/plain (text body -- kept)
>  text/html
>The reason this message is shown is because the post was in HTML
>or had an attachment. Attachments are not allowed.
>Please post in Plain-Text only.---
>_______________________________________________
>Elecraft mailing list: [email protected]
>You must be a list member to post to the list.
>Postings must be plain text (no HTML or attachments).
>See: http://mailman.qth.net/mailman/listinfo/elecraft
>Elecraft Web Page: http://www.elecraft.com
>