[Elecraft] Frequency calibration

Thu Jun 20 12:11:00 2002

Hi

I set up a marker at 500 and 600 Hz in Spectrogram. Then adjust the k2 so=
 the WWV 500 and 600 Hz tones are centered on the markers. The markers ar=
e on most alternate minutes. Then read the K2 display and see how much it=
 is off. Adjust the 4 MHZ master clock on the control board by the same a=
mount as the error as described in the manual. Then do the PLL calibratio=
n and recheck WWV with Spectrogram. You may have to do this procedure sev=
eral times to get it perfect.

Don Brown
KD5NDB

----- Original Message -----
From: [email protected]
Sent: Thursday, June 20, 2002 10:53 AM
To: [email protected]
Subject: [Elecraft] Frequency calibration

Howdy group,
   Does anyone have a procedure written up for calibrating the frequency =
on the K2 using Spectrogram?  I have used this
software to tune my CW and SSB filters but I would like to use it to get =
my K2's frequency readings a little closer to what
they should read.
   Kevin.

_______________________________________________
Elecraft mailing list: [email protected]
You must be a list member to post to the list.
Postings must be plain text (no HTML or attachments).
See: http://mailman.qth.net/mailman/listinfo/elecraft
Elecraft Web Page: http://www.elecraft.com

--- StripMime Report -- processed MIME parts ---
multipart/alternative
  text/plain (text body -- kept)
  text/html
The reason this message is shown is because the post was in HTML
or had an attachment. Attachments are not allowed.
Please post in Plain-Text only.---