[Elecraft] Help needed with KPA100

[Phil Wheeler]

Todd Gahagan wrote:

>Thanks Phil,
>I have checked all those.  All the voltages are correct on U1 except for pin
>25 where I get 0 volts and I believe the chart says it should be 4.9V.  
>
Be sure to check all non-U1 voltages, too, Todd.

>I am
>in the process if checking the ribbon cable again.  First time it seemed to
>be OK.  I still think its some kind of firmware problem but can't prove it
>at this point.
>

Could be.  I zapped my 2.02x MCU during the FT programs and had to wait 
for a replacement.  Symptoms were very different, though.

73, Phil