[Elecraft] Help needed with KPA100

[Todd Gahagan]

Thanks for the tip. I should have stated that Elecraft says that I really do
have 2.02F and that the label on the chip is wrong.  The firmware does show
the PA option.  Todd
----- Original Message -----
From: "Mark Flavin" <N5MF@dfn.com>
To: "Todd Gahagan" <tgahagan@imt.net>
Sent: Tuesday, June 18, 2002 5:57 AM
Subject: Re: [Elecraft] Help needed with KPA100


> Top right of page 21 states the 2.02 firmware MUST be installed
>
>
> ----- Original Message -----
> From: "Todd Gahagan" <tgahagan@imt.net>
> To: "Elecraft List" <Elecraft@mailman.qth.net>
> Sent: Monday, June 17, 2002 6:00 PM
> Subject: [Elecraft] Help needed with KPA100
>
>
> > I got to the point in construction where the KPA board is connected to
the
> > K2 via the ribbon cable.  The K2 won't see the amp.  I have checked
> voltages
> > on the ICs contained on the amp board and all are proper.  All
resistance
> > checks were also proper.  I don't have the correct firmware for the SSB
> > board but that is on its way from Elecraft.  I don't believe that could
be
> > the cause.  I have checked for bad solder joints, improper component
> > placement, etc. The secondary menu in the K2 firmware shows the PA
setting
> > with two dash marks behind it indicating that the PA is not present.  I
> sure
> > could use some ideas. Thanks, Todd   WA7U
> >
> > _______________________________________________
> > Elecraft mailing list: Elecraft@mailman.qth.net
> > You must be a list member to post to the list.
> > Postings must be plain text (no HTML or attachments).
> > See: http://mailman.qth.net/mailman/listinfo/elecraft
> > Elecraft Web Page: http://www.elecraft.com
> >
>
>
>