[Elecraft] Power output

[Gary L Surrency]

Using the wrong type of core at T1 or T2 can also cause this. Make sure
these are FT37-43 grey cores.

73,

Gary Surrency AB7MY


On Mon, 10 Jun 2002 22:24:50 -0400 "Don Wilhelm" <w3fpr@peoplepc.com>
writes:
> Bob,
> 
> You should have at least 10 watts of power on 10 meters (assuming 
> you are
> feeding a 50 ohm non-reactive load - like a good dummy load or a 
> properly
> tuned antenna).
> 
> The low pass filters as well as T4 can reduce your power output.
> 
> Check T4 (and T3 too) for the correct number of turns.  Gary 
> Surrency has
> said that T4 works much better if the turns are interlaced rather 
> than just
<SNIP>

________________________________________________________________
GET INTERNET ACCESS FROM JUNO!
Juno offers FREE or PREMIUM Internet access for less!
Join Juno today!  For your FREE software, visit:
http://dl.www.juno.com/get/web/.