[Elecraft] SSB Front Panel: P1->mic connector wiring?

[Tom Hammond NØSS]

I only WISH the IDC connector had been my idea!

The original idea came from David Belsley (W1EUY). I just happened to write 
up a bit of documentation for it.

If you'd like to see the write-up, drop by my web site at:

   home.earthlink.net/~n0ss/download.html

and look under "K2-related Files".

73,

Tom  N0SS

Donald Wilhelm wrote:
>If you keep in mind that the left column of pins are connected to the inards
>of the K2 while the right column pins connect to the corresponding pins of
>the mike connector, you should be able to wire it for most any mike.  For
>the elecraft mic, the pins are wired straight across, and you can even use
>the configuration jumpers from old computer I/O cards to make the
>connections rather than soldering to the pins of P1 - much better if you
>ever change mics in the future.
>
>Tom, N0SS had a great method for using the IDS connectors from a computer
>cable to make the connections too.  You cut the connector with enough pins
>(sockets) to mate with the pins of P1 and do all the soldering on top of the
>connector block.
>
>73,
>Don W3FPR
>
>----- Original Message -----
> > Hello, everyone.
> > I just installed P1 on the front panel board and I am ready to run the
>wires
> > over to the mic connector.
> >
> > Question: Looking at the back of the front panel board, with U1 at the top
> > and the mic connector on my right, what row of pins on P1 do I connect to
> > the pins on the mic connector - the left row (marked AF, PTT, etc) or the
> > right row (marked 1,2,3...).
> >
>
>
>_______________________________________________
>Elecraft mailing list: Elecraft@mailman.qth.net
>You must be a list member to post to the list.
>Postings must be plain text (no HTML or attachments).
>See: http://mailman.qth.net/mailman/listinfo/elecraft
>Elecraft Web Page: http://www.elecraft.com