[Elecraft] KPA100 Resistor R9

Sat Jul 6 00:28:01 2002

Brown-Black-Black is 10 Ohms.

Brown Black Brown is 100 Ohms.

I had to do a double take when I was looking through the manual of my K2
last night...... The chart that Elecraft includes in the manual is VERY
CONFUSING to say the least!  I wish they would have used the "STANDARD"
chart out of the Handbook or similar.

I don't need to use a chart but when I looked at it......It was confusing to
say the least!

73
Jim W7RY # 2740

----- Original Message -----
From: "G. Thisell" <[email protected]>
To: <[email protected]>
Sent: Friday, July 05, 2002 5:24 PM
Subject: [Elecraft] KPA100 Resistor R9

> The only resistor I have left is
> Brown  1:st figure = 1
> Black  2:nd figure = 0
> Black  3:d  figure = 0
> Black  4:th figure = multiplication = 0
> Brown  Tolerance
>
> So R9 is supposed to be 10 ohms but seems in my case to be 100 ohms.
> Can be checked on line. (With the resitor in place..)
> The resistor has to do with bias set, so it might be critical...
>
> I have probably mixed it all up, so I will have to check again..
>
> Best regards
>
> Joe
> SM5BFK
>
>
>
> _______________________________________________
> Elecraft mailing list: [email protected]
> You must be a list member to post to the list.
> Postings must be plain text (no HTML or attachments).
> See: http://mailman.qth.net/mailman/listinfo/elecraft
> Elecraft Web Page: http://www.elecraft.com
>
>