[Elecraft] OP1 - 5

[Vic Winton]

All,

Do I read this right?

Can I really set OP 2 - 5 differently and therefore do as Don suggests?

So,if I understand this correctly,  for ssb use I can set FL1-4 as follows:
FL1 as OP and FL2-4 as cw the filter at various widths (say 2.0,  1.8 etc).
But IN ADDITION my FL1 setting can be varied if I switch between OP1 - 5.
Thus I get a switchable IF shift effect.

Is this correct?

Presumably the OP 1-5 switching could be put on to one of the programmable
buttons to make it easier than scrolling througgh the menus...

Why did I not realise this before?

Regards,


Vic   GW4JUN

K2 1926

snip...
Hi

OP1 - OP5 are all the same and select the SSB module. I guess the other
OP3-5 may be for future filter modules but for now OP1 is used on transmit
and OP2 is used on receive. You can set up the filters for OP2- OP5 and
shift the BFO setting for each to simulate IF tuning


Don Brown
KD5NDB
snip...

****** Internet Email Confidentiality ****** 
Privileged/Confidential Information may be contained in this message.  If
you are not the addressee indicated in this message (or responsible for
delivery of the message to such person), you may not copy or deliver this
message to anyone. In such case, you should destroy this message and kindly
notify the sender by reply email. Please advise immediately if you or your
employer do not consent to Internet email for messages of this kind. 

Opinions, conclusions and other information in this message that do not
relate to the official business of Carrington Wire Ltd shall be understood
as neither given nor endorsed by it. 
********************************************