[Elecraft] 2E1LOK receives K2 & SSB Serial No. 2448

Wed Jan 23 09:06:00 2002

Yes, I have #2456 on the air. Only one chip in the kit. There are =
instructions for swapping the chip, but it says don't bother if you only =
have one. Run through the manual and scribble in the erratta in place. =
You'll never remember the alignment step changes that need to be made =
without it - That's over 40 hours away!

Good luck.

btw, every single missing part in my kit (there were several) was just =
in the bag I wasn't looking in at the time. Well, there was that 10 ohm =
resistor I dropped after trimming the leads. My knees feel better now.

Dan / WG4S / #2456

-----Original Message-----
From: [email protected]
[mailto:[email protected]]On Behalf Of Nicholas Lokuciewski
Sent: Wednesday, January 23, 2002 1:35 PM
To: [email protected]; [email protected]
Subject: [Elecraft] 2E1LOK receives K2 & SSB Serial No. 2448

Hi All,

Finally got the kit today (Ser No. 2448)! So now Id better do an =
inventory=20
;) (All I need now is that M3LOK licence I applied for).

Included in the parcel, was a firmware upgrade to version 2. I =
understand=20
the changes that have to be made to the manual. With this upgraded =
firmware,=20
does this mean that this is the only version 2 of the chip included in =
the=20
kit?

73 2E1LOK (Nicholas)

_________________________________________________________________
Send and receive Hotmail on your mobile device: http://mobile.msn.com

_______________________________________________
Elecraft mailing list: [email protected]
You must be a list member to post to the list.=20
Postings must be plain text (no HTML or attachments).=20
See: http://mailman.qth.net/mailman/listinfo/elecraft
Elecraft Web Page: http://www.elecraft.com