[Elecraft] KFL1-4

Mon Jan 14 23:32:01 2002

Thanks again, guys. I was SURE that was the way it was supposed to be, but
the surer I was, the less I wanted to solder it until I asked.

Andy W5VCJ

----- Original Message -----
From: "Rod N0RC" <[email protected]>
To: "Alva Anderson W5VCJ" <[email protected]>; "elecraft-reflector"
<[email protected]>
Sent: Monday, January 14, 2002 8:37 PM
Subject: Re: [Elecraft] KFL1-4

> Andy,
>
> I got tripped up on that too. Then, I realized that any time a wire
> passes _through_ a toroid center, it counts as one turn. So, in the
> picture on the left there are eight turns as you noted. In the picture
> on the right there are still eight turns: 1-7 wrap tightly around the
> inner surface of the toroid. Turn eight, instead, passes through the
> center from the top of the figure to the bottom.
>
> Another way to look at it: Consider the Left hand picture with eight
> turns. Now take lead #2 unwind and/or fold it down, so that it is on
> the backside of the toroid, as pictured, positioned between lead #4
> and lead #3, as in the right hand figure.
>
> Hope that helps.
>
> GL
> 73, Rod N0RC
> Ft Collins, CO
>
>
>
> ----- Original Message -----
> From: "Alva Anderson W5VCJ" <[email protected]>
> To: "elecraft-reflector" <[email protected]>
> Sent: Monday, January 14, 2002 3:27 PM
> Subject: [Elecraft] KFL1-4
>
>
> > I am building the 4 band  module to replace the current two band one
> in K1
> > #636. On page 12, Rev A, dtd 17Oct2001, the T1/T2 windings
> instructions are
> > a bit ambiguous.  Step 5 says to wind 8 turns of green, and that is
> how the
> > picture is labelled. That is, there are 8 turns without the lead
> down
>
>
> _______________________________________________
> Elecraft mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/elecraft
> Elecraft Web Page: http://www.elecraft.com
>