[Elecraft] Griefkit parts...

[Dan Barker]

Steve:

I just went through the pile of gear in the shack obsoleted by my K2, =
and find:

 SB-634  Station Console (OK condition, book, 1 paddle knob-Black);
 HD-1410 Keyer           (Fairly hacked up, book, Reversing switch, =
extra bias for solid-state keying, no paddles, no paddle knobs);
 SB-614  Station Monitor (Like New condition, book, 3 paddle =
knob-Black);
 SA-2040 Antenna Tuner   (OK condition, book, no paddle knobs);
 HN-31   Cantenna        (Oily condition <duh>, book, no paddle knobs);

Wanna make me some room?

Dan / Atlanta / WG4S / K2 #2456

-----Original Message-----
From: elecraft-admin@mailman.qth.net
[mailto:elecraft-admin@mailman.qth.net]On Behalf Of Steve Banks
Sent: Wednesday, February 27, 2002 11:44 AM
To: Elecraft Corporation; Rich Lentz
Subject: RE: [Elecraft] External keyer question...


Rich-

<snip>

Specifically, I'm looking for two of the tab-style flat "knobs" (the =
flat,
quarter-sized ones with the little green thumb tabs) which fit behind =
the
FINAL and AF GAIN controls on an HW101 I'm reworking.  These two "knobs"
(one selects the SSB/CW filters and the other is situated behind the =
FINAL
load control) have suffered irrepairable damage, and I'd like to replace
them rather than haywiring else something together.  I've acquired =
several
other good spares that are often needed for the HW, but the little =
tab-style
knobs are elusive.

If anyone has any suggestions, feel free to point me at a link or other
source.

Thanks again, Rich for your keyer suggestion.  (And thanks too to Eric =
for
the bandwith.)

73

Steve Banks
K0PQ
K2 S/N 1599