[Elecraft] K2

Wed Feb 13 15:11:48 2002

The instructions for setting the null are FOLLOWED by the instruction to =
install R6. However, there is a picture of the boards PRECEEDING the =
null set which points out R6. (That's the point I installed it. - I =
removed it for the null, and then put it back - doesn't seem to make any =
difference). Earlier still in the book, it says not to confuse R5 and =
R6, but doesn't SPECIFICALLY say to install R6 or not.

Probably doesn't matter. Anyhow, my KAT2 works fine! How's yours?

Dan / WG4S / K2 #2456

-----Original Message-----
From: [email protected]
[mailto:[email protected]]On Behalf Of Glenn Eisenbrandt
Sent: Wednesday, February 13, 2002 12:26 PM
To: [email protected]
Subject: [Elecraft] K2

A while back there was a string about resistor  R6 and not installing it =

until after setting the null. I don't find any such instructions. The=20
 R6  resistors were said to be installed as constructed.   Which  R6 on=20
which board in which instruction book?
WA9VYL

_______________________________________________
Elecraft mailing list: [email protected]
You must be a list member to post to the list.=20
Postings must be plain text (no HTML or attachments).=20
See: http://mailman.qth.net/mailman/listinfo/elecraft
Elecraft Web Page: http://www.elecraft.com