[Elecraft] KAT100-1 Firmware Question

Fri Dec 27 12:33:11 2002

Hi

The manual is correct you need 2.03d or later. The KAT100 should come with
the firmware upgrade as part of the kit. Call Elecraft and get the correct
chip sent out It looks like your SSB is ok but you need a new MPU and IOC
chip

Don Brown
KD5NDB

----- Original Message -----
From: "Peter Lutz AA6AV" <[email protected]>
To: <[email protected]>
Sent: Friday, December 27, 2002 10:50 AM
Subject: [Elecraft] KAT100-1 Firmware Question

> Friends:
> Page 24 of the KAT100 manual specifies that firmware rev. 2.03d or
> later is required, along with IOC 1.07 or later.  When I fire up my K2
> (#1294) with what I thought were all the latest (or at least quite) late
> chips, the front panel displays 2.02f   1.02.  Inside the box, the SSB
> processor chip says 1.07 on the tag and the big chip on the controller
> board says 2.02f.  Will this set up operate the KAT100-1, and if not,
> when did Elecraft stop sending the required firmware upgrades with
> kits?  Is 2.03d a typo that should be 2.02d?  I can find no mention
> of 2.03d on their web site.  Any suggestions would be greatly
> appreciated.
>
> Thank you.
> 73
> Peter
>
>
> ---
>
> Checked by AVG anti-virus system (http://www.grisoft.com).
> Version: 6.0.423 / Virus Database: 238 - Release Date: 11/25/2002
>
>
> --- StripMime Report -- processed MIME parts ---
> multipart/mixed
>   text/plain (text body -- kept)
>   text/plain (text body -- kept)
> The reason this message is shown is because the post was in HTML
> or had an attachment. Attachments are not allowed.
> Please post in Plain-Text only.---
> _______________________________________________
> Elecraft mailing list: [email protected]
> You must be a list member to post to the list.
> Postings must be plain text (no HTML or attachments).
> See: http://mailman.qth.net/mailman/listinfo/elecraft
> Elecraft Web Page: http://www.elecraft.com
>