[Elecraft] K2 control board R1 (50k pot)

[Tom Hammond NØSS]

Ewan, et al:

>K2 s/n 3080 control board part No e520011 agc threshold 50k trimmer.
>
>The supplied part (which looks different from photo in parts list) has 
>waisted legs which means that they only partially  pass thru pcb holes and 
>the pot remains proud of the board by about 5mm (1/4 inch).
>
>The mannual states that the pot must be seated flat against the board but 
>this is not possible. Has anyone else encountered this problem?

This pot should be seated until the SHOULDERS of the legs (not the BODY) 
seat flush against the PC board.

73,

Tom  N0SS