[Elecraft] Re: kat2 problem after installing battery

[Wayne Burdick]

Gary,

When you tap ANT1/2, do you hear a relay switching in the KAT2? If not, the
control cable between the KAT2 and Control board is probably disconnected,
plugged in wrong, or has a broken wire. If you do hear a relay switch switch,
the KAT2 is probably connect right but may be in CALP mode rather than AUTO mode
(ATU menu entry).

73,
Wayne

Gary Lee wrote:
> 
> Well, we installed the battery option last night.  It was late by the time
> we weree done, so didn't try to operate any.
> 
> Tried tonight, and when "tune" is pressed, I get a beep, the audio mutes,
> then nothing.  No relay chatter, nothing.
> 
> Any ideas out there in elecraft land?  Something to tell Jeff (elmer
> solderer, and reader of schematics) where to start.
> 
> I'm totally blind, so can't tell you what the display says.
> 
> Thanks for any help.  Guess I'll have to use the ts2000 for the ten meter
> contest.
> 
> Gary Lee
> kb9zuv
> 9