[Elecraft] ssb argh

Thu Dec 5 11:02:00 2002

Hi

If you are building a B model (>3000 S/N) then there is not a pot for r60,
it is a 100 ohm fixed resistor.

The manual method of setting R1 is good but I do it a little differently. I
use my OHR wattmeter set on the 100 mW scale and adjust R1 for minimum
output while holding the PPT button and no sound into the microphone.

Don Brown

----- Original Message -----
From: "David Schornak" <[email protected]>
To: "Elecraft" <[email protected]>; <[email protected]>
Sent: Thursday, December 05, 2002 9:38 AM
Subject: Re: [Elecraft] ssb argh

> okay I found the two little toriod where grounding out on the two crystals
> next to them and I fixed that now there is no r60 variable pot on the rf
> board as the ssb instructions talk about ?????/
> also when I try to adjust r1 on the ssb card nothing seems to happen
>
> I lost here any help
>
>
> ----- Original Message -----
> From: "David Schornak" <[email protected]>
> To: "Elecraft" <[email protected]>
> Sent: Wednesday, December 04, 2002 11:38 PM
> Subject: [Elecraft] ssb argh
>
>
> okay I installed the audio filter the noise blanker and the ssb had to
> remove the ssb because it was killing the audio the noise blanker and the
> audio filter installed and are working fine now but the ssb when installed
> mutes the audio to such a level that I can hear anything out of the
speaker
> except for the strongest signal such as wwv at 10000
> what besides the obvious should I be looking for on the ssb or is this
> typical until I a line all the filters.
>
> see ya
>
> 73's
> KG4LSK
> David Schornak
>
> K2 03027
>
> arf arf arf
> don't forget me
> Mis Ginger
>
>
> --- StripMime Report -- processed MIME parts ---
> multipart/alternative
>   text/plain (text body -- kept)
>   text/html
> The reason this message is shown is because the post was in HTML
> or had an attachment. Attachments are not allowed.
> Please post in Plain-Text only.---
> _______________________________________________
> Elecraft mailing list: [email protected]
> You must be a list member to post to the list.
> Postings must be plain text (no HTML or attachments).
> See: http://mailman.qth.net/mailman/listinfo/elecraft
> Elecraft Web Page: http://www.elecraft.com
>
> _______________________________________________
> Elecraft mailing list: [email protected]
> You must be a list member to post to the list.
> Postings must be plain text (no HTML or attachments).
> See: http://mailman.qth.net/mailman/listinfo/elecraft
> Elecraft Web Page: http://www.elecraft.com
>