[Elecraft] Raised T2 falling down

[Kevin Cozens]

At 04:17 PM 08/25/2002 +0200, you wrote:
>I raised mine 1-2 mm above the board when I built my K2 a year ago.
>Yesterday when I was installing the Aux RF connector for the KAT2, I
>checked it again and noticed that it was flush with the board.
>Apparantly, gravity is enough for it to 'fall down', so I put some
>plastic spacers under it to keep it up.

When I raised T2 in my K2 hoping to get a slight increase in the output on 
10m, I cut a small square piece of perf board and trimmed it to roughly a 
circle and place it underneath the toroid. This is just another idea on 
what you can use to elevate T2.


Cheers!

Kevin.  (http://www.interlog.com/~kcozens/)

Owner of Elecraft K2 #2172        |"What are we going to do today, Borg?"
E-mail:kcozens at interlog dot com|"Same thing we always do, Pinkutus:
Packet:ve3syb@ve3yra.#con.on.ca.na|  Try to assimilate the world!"
#include <disclaimer/favourite>   |              -Pinkutus & the Borg