[Elecraft] Raised T2 falling down

[Sverre Holm - LA3ZA]

I have seen several messages about raising T2 1/16 to 1/8 of an inch
above the board (1-4 mm). Supposedly it helps raise the maximum output
power - I have never measured to check this.

I raised mine 1-2 mm above the board when I built my K2 a year ago.
Yesterday when I was installing the Aux RF connector for the KAT2, I
checked it again and noticed that it was flush with the board.
Apparantly, gravity is enough for it to 'fall down', so I put some
plastic spacers under it to keep it up.

Just wanted to share my experience in case someone else expects their T2
still to be raised after a long time.

73 Sverre




Sverre Holm, LA3ZA
Asker, Norway (59.8N, 10.4E)
---------------------------------
www.qsl.net/la3za