[Elecraft] KPA100: Wire size for Z1 - is #22 enough?

Mon Aug 19 09:05:01 2002

I save the clipped leads from the 1N4007 diodes to use for all of the jum=
pers on the boards (grounds, options, ect.) they are about .030 or 22 GA =
and work well. I would not use enameled wire because of the problems of s=
tripping and getting a good solder joint. If you want an even heaver wire=
 for Z1 then save the wire clipped from the .005 ohm current sensing resi=
stor. =20

Don Brown
KD5NDB

----- Original Message -----
From: [email protected]
Sent: Monday, August 19, 2002 6:42 AM
To: [email protected]
Subject: [Elecraft] KPA100: Wire size for Z1 - is #22 enough?

Hello to the fellow builders,
after all these toroids...
Would a piece of #22 enameled wire be good enough as a basis - there
are =20
warnings not to use small component leads. #22 wire might be a bit
small for =20
20A?
-- =20
Best Regards
Mit freundlichen Gr=FC=DFen
Rolf Schr=F6der
Mail: [email protected]

They that can give up essential liberty to obtain a little temporary
safety deserve neither liberty nor safety. =20
- Benjamin Franklin, 1759 - _____________________________________________=
__
Elecraft mailing list: [email protected]
You must be a list member to post to the list. =20
Postings must be plain text (no HTML or attachments). =20
See: http://mailman.qth.net/mailman/listinfo/elecraft
Elecraft Web Page: http://www.elecraft.com

--- StripMime Report -- processed MIME parts ---
multipart/alternative
  text/plain (text body -- kept)
  text/html
The reason this message is shown is because the post was in HTML
or had an attachment. Attachments are not allowed.
Please post in Plain-Text only.---