[Elecraft] KSB2 Module - board pad

[Ed Tanton]

What you need to do Tom, is:

1) Tin, attach, & solder a small (enamel, for example) wire to each of the 
capacitor leads, right where the lead enters the capacitor body.

2) Determine where the printed-circuit run is for each of your missing pads 
and scrape some of the PCB Masking (DON'T scrape through the run!) from 
each of the appropriate runs. Tin them with a blob of solder (NOTE: these 
points are  ** outside **  the radius of the capacitor body).

3) Replace the capacitor in the holes and solder the bottom side.

4) Now tin and solder your two leads to the two spots you have already 
prepared.

You now have a connection on both the top, and the bottom sides.



72/73 Ed Tanton N4XY <n4xy@earthlink.net>

Ed Tanton N4XY
189 Pioneer Trail
Marietta, GA 30068-3466

website: http://www.n4xy.com

All emails <IN> & <OUT> checked by
Norton AntiVirus with AutoProtect

LM: ARRL QCWA AMSAT & INDEXA;
SEDXC NCDXA GACW QRP-ARCI
OK-QRP QRP-L #758 K2 (FT) #00057