[Dxbase] Can't print my QSL cards

[Knut Meland]

Forget it. I found DXBase ver 1.05, not 1.10, and that explains all. Ver 
1.10 is now installed, and problems gone.
73 de Knut LA9RY

Den 26.04.2016 09:28, skrev Knut Meland:
> I made some QSL card design and was satisfied with that.
> Then I had a harddisk failure and had to move my designs to a new disk.
> Today I could not load some of my designs.
> The error messages:
> * File is password protected og has invalid format.
> /Checked this. Properties says nothing about protected.
>
> /* Error: printer definition file bad or defective
> /Is there a printer definition file for each card design?
>
> /* The project file cannot be opened. Either you don't have enough 
> network rights or the project is being edited at the moment.
> /How can I find out? Sure I don't edit more than one file at a time
>
> /An empty design project follows.
>
> Redesign might be a solution, but is there a way to sort this out 
> filewise?
>
> I am using W10 Home edition, 64 bits and DxBase 1.10
>
> 73 de LA9RY Knut
> ______________________________________________________________
> Dxbase mailing list
> Home: http://mailman.qth.net/mailman/listinfo/dxbase
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Dxbase at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html