[Dxbase] Can't print my QSL cards

[Knut Meland]

I made some QSL card design and was satisfied with that.
Then I had a harddisk failure and had to move my designs to a new disk.
Today I could not load some of my designs.
The error messages:
* File is password protected og has invalid format.
/Checked this. Properties says nothing about protected.

/* Error: printer definition file bad or defective
/Is there a printer definition file for each card design?

/* The project file cannot be opened. Either you don't have enough 
network rights or the project is being edited at the moment.
/How can I find out? Sure I don't edit more than one file at a time

/An empty design project follows.

Redesign might be a solution, but is there a way to sort this out filewise?

I am using W10 Home edition, 64 bits and DxBase 1.10

73 de LA9RY Knut