[Dxbase] Mode Overide

[FireBrick]

This is tricky but you can.
Open Tools>Options>Log Defaults> and select Alternate from the Band Plan Selection.
then
Open the Tools>Options>Band Plan Mapping
(make sure the heading shows the 'alternate Mapping Table'

Then cursor through till you see the appropriate section of the band plan and correct the 
numbers.

The important thing is....make sure you don't have any conflicting listings.
Where the same section of band is mentioned twice.


----- Original Message ----- 
From: "Bob Main" <bobmain1 at alltel.net>
To: "DXBase" <dxbase at mailman.qth.net>
Sent: Friday, October 28, 2005 6:16 PM
Subject: [Dxbase] Mode Overide


> I've noticed that during SSB contests that "others" run SSB where we use CW
> and listen up on 40 and 80.  I'm finding that when I click on one of these
> spots that my rig changes to CW because that is our mode of operation down
> there.  So I switch back to LSB and then have to retune to get back to the
> correct frequency.  Is there something in the User Options that I can check
> or uncheck so that I will stay SSB during these times?
>
>
>
> Bob
>
> KB4CL
>
> ______________________________________________________________
> Dxbase mailing list
> Home: http://mailman.qth.net/mailman/listinfo/dxbase
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Dxbase at mailman.qth.net
>