[Dxbase] Counties

[Joseph Glockner]

Jim,

I just typed in a dummy qso in my 2006 logbook with a
California buddy of mine -- once I typed in his callsign
and hit the TAB Key -- I went over and typed in/selected
CA in the state column - then (in lower case), just "started"
typing in the County column with "lo" (without the quotemarks)
(for Los Angeles County) -- and then took my mouse cursor
over to the drop-down arrow -- and VOILA!! Right there was
LOS ANGELES !!

Is there something different that you are going there Jim?

73 Joe wa6axe


Mail fromJim/Connie wrote:

> Previously in DXbase 2005 when a particular state was entered, then after the first few letters of a county was being typed, (either in upper or lower case)  the county would jump to a completed county.
> Now in DXbase 2006 if you try to type the county name in lower case, the county name will not be entered.  It must be typed in upper case, plus the complete county name must be typed, or you must go to the drop down and make a selection.
> Is this the way it should operate.
> Is there anyway I can go into the 2005 directory and move the previous procedure into 2006.
> 
> 
> VA6JR Jim  
> ______________________________________________________________
> Dxbase mailing list
> Home: http://mailman.qth.net/mailman/listinfo/dxbase
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Dxbase at mailman.qth.net
>