[Dx4win] Anyone using the rotor interface to a Yaesu G-1000DXA?

[Lee Hallin]

I am considering getting this rotor.  Is anyone using one with DX4WIN (9.0x).

Questions:
  What interface do you use to control the rotor (Eg. Easy-Rotor-Control,Rotor Card,etc)?
	    Does the interface work well?
	    If you use the ERC, 
		    does DX4WIN take advantage of the "start slow, then speed up in mid turn, then slow down at the end"
	    Would you get the same interface again or has something "better" become available?

  As for the rotor itself, has it worked well for you?  How long?

  Does the manual controller work well?

  Is there a way to restrict the range to only 360 degrees (temporarily)?  
	   I would like to use rotor sooner than later but can't replace the coax yet (to allow for the 450 degree rotation.  
	   Don't want to break something while turning too far!

Thanks for any feed back.

73,
Lee  N7NU