[Dx4win] Can not get DX spots to talk to radio

[David Kozinn, K2DBK]

Hi Steve,

Can you provide more details about the new configuration? It sounds like 
D4W is seeing the frequency information so however you've got it hooked 
up at least it's able to read that.. Are you using the USB adapter for 
CI-V control? Assuming so since you said you turned translate (I think 
you meant transceive) off. Did you install the USB drivers before you 
connected? The documentation warns about doing that, but I don't know 
specifically what happens if you connect without the drivers being in 
place first.

I guess the other things to check would be to make sure that when you 
transferred over to the new computer that the setup in Preferences for 
the radio match what you've got configured, in particular the port and 
baud rate settings. (Although if you're getting frequency information, 
it would seem less likely that's an issue.)

73,

David, K2DBK


On 4/12/2017 8:29 PM, Steve Barber wrote:
> I am not able to get the DX4WIN program to transfer the spot frequency to my Icom 7600.  I changed from a windows XP computer that was working fine but the frequency that is displayed on the Icom 7600 always shows up in the program's frequency window.  I turned the CIV Translate off to no avail.  Any suggestions are appreciated.  Thanks, Steve - WA4B
> ______________________________________________________________
> DX4WIN mailing list
> Home: http://mailman.qth.net/mailman/listinfo/dx4win
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:DX4WIN at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html

-- 
73,
	David, K2DBK
	http://k2dbk.blogspot.com
	http://k2dbk.com
	twitter: @k2dbk