[Dx4win] (no subject) VFO A/B Flash

[Dan Violette]

I think this is an ICOM software (CI-V?) issue.  DXlab does it to an IC756
also at the club station.  I have never had it happen with my Kenwood.
Seems to be a command that connects the ICOM radio to the software causes
things to switch to the sub-VFO for a couple seconds and then back.  With a
SteppIR hooked up and the alternate VFO on a different freq/band, the
controller starts changing the antenna and then reverses and changes back
when main VFO comes back.

Dan KI6X

-----Original Message-----
From: dx4win-bounces at mailman.qth.net [mailto:dx4win-bounces at mailman.qth.net]
On Behalf Of Marcel ON6UQ
Sent: Wednesday, September 11, 2013 1:16 AM
To: DX4WIN at mailman.qth.net
Subject: [Dx4win] (no subject)


Hello all, 


Hello all, 

Have recently installed a IC7600 and a connection established between the
TRX and the laptop with XP via USB ports. 

Both DX4WIN as N1MM works ok . 
When I start DX4WIN , then flashes the VFO frequency readouts of both of VFO
A and B . 
Does anyone have any idea what the reason of this is and what to do? 


In the DX4WIN window 'Freq (khz)' no readout, only a few seconds by pressing
F9 and than disappear. 

Thanks in advance 
MarCEL ON6UQ 

______________________________________________________________
DX4WIN mailing list
Home: http://mailman.qth.net/mailman/listinfo/dx4win
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:DX4WIN at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html