No subject

MODE command Cat manual page 12 FTDX5000 shows
P1 0: main (VFO-A)
P1:1: sub (VFO-B)

FTDX5000 cmd =3D MD0; =3D in this case reads mode from VFO-A
FTDX5000 cmd =3D MD1; =3D in this case reads mode from VFO-B

For setting the modes on FTDX5000 its something similar

FTDX5000 cmd =3D MD01; =3D in this case sets mode from VFO-A to LSB =20
FTDX5000 cmd =3D MD11; =3D in this case sets mode from VFO-B to LSB

First number is for the VFO selection and second number(or letter not =
yet
supported by dx4win) for the mode.

Page 11 from the FTDX 3000 CAT manual shows now a BIG PROBLEM
P1 =3D 0:fixed

Yaesu claims now also like Icom is doing over the years that there are =
not 2
VFO=B4s
Because there are not 2 receivers but only one inside the radio for them =
its
only a second VFO A with different stack=20
and not a real VFO B

Maybe with the cmd AB --> VFO A to VFO=B4A=B4(vfoB) it could work but
Need a radio here to test that out before any release  =20

Guy =20

-----Oorspronkelijk bericht-----
Van: jjreisert at gmail.com [mailto:jjreisert at gmail.com] Namens Jim Reisert
AD1C
Verzonden: maandag 8 april 2013 15:55
Aan: ON4AOI
CC: john at w9rpm.com; DX4WIN Reflector
Onderwerp: Re: [Dx4win] support for the new Kenwood TS-990

On Sun, Apr 7, 2013 at 10:31 PM, ON4AOI <on4aoi at skynet.be> wrote:

> There can=B4t be any support for the FT3000 rig file Not from me or =
Paul=20
> or anyone else.
>
> YAESU left OUT the cat commands for VFO-B and related Mode So as long=20
> there are no commands in the ft3000 firmware It is impossible

So why can't there be a driver that treats the radio like it only has =
one
VFO?  The ability to read the current VFO and assume simplex operation =
is
better than nothing, right?

--
Jim Reisert AD1C, <jjreisert at alum.mit.edu>, http://www.ad1c.us