[Dx4win] Default Spot Bandwidth

[Mel]

Whatever you set it to in the menu. It's actually width 1,2 and 3 which 
normally corresponds to wide, medium and narrow but you can set it to 
whatever you like. Then you modify the command mask in the rig file for 
mode to select the proper width. This works with all icoms though older 
rigs only support width 1 and 2. which becomes wide and narrow.

On 2011-02-16 23:55, Dick Flanagan wrote:
> Oh, goodie! My radio has five preset bandwidths: 250 Hz, 500 Hz, 1.8
> kHz, 2.4 kHz and 3.0 kHz. Now I just have to figure out what the radio
> considers to be wide, medium and narrow. :(
>
> Thanks, Mel.
>
> Dick
>
> At 08:06 PM 2/16/2011, Mel wrote:
>  >Yes and no...
>  >
>  >You can set your bandwidth to wide, medium or narrow, not a specific
>  >bandwidth. Also, it's not mode specific... if you use medium, for
>  >example, it will be medium for all modes. What that corresponds to in
>  >bandwidth depends on how you set up the radio.
>  >
>  >On 2011-02-16 22:51, Dick Flanagan wrote:
>  >> When I use DX4WIN to move to spots with my IC-7700, the radio is set
>  >> to default bandwidths of:
>  >>
>  >> CW - 250 Hz
>  >> RTTY - 250 Hz
>  >> SSB - 1.8 kHz
>  >>
>  >> How can I change these default spot bandwidths to:
>  >>
>  >> CS - 250 Hz
>  >> RTTY - 500 Hz
>  >> SSB - 2.4 kHz
>  >>
>  >> Are these contained in the .rig file and, if so, are they easily
> changed?
>  >>
>  >> Dick
>  >> --
>  >> Dick Flanagan K7VC
>  >> dick at k7vc.com
>  >>
>  >> ______________________________________________________________
>  >> Dx4win mailing list
>  >> Home: http://mailman.qth.net/mailman/listinfo/dx4win
>  >> Help: http://mailman.qth.net/mmfaq.htm
>  >> Post: mailto:Dx4win at mailman.qth.net
>  >>
>  >> This list hosted by: http://www.qsl.net
>  >> Please help support this email list: http://www.qsl.net/donate.html
>  >>
>  >
>  >
>  >
>  >
>  >
> --
> Dick Flanagan K7VC
> dick at k7vc.com
>
>