[Dx4win] Serial ports

[David Warr]

Hello,

All sorted now thanks for all the replies received direct...

David


-----Original Message-----
From: dx4win-bounces at mailman.qth.net
[mailto:dx4win-bounces at mailman.qth.net]On Behalf Of David Warr
Sent: 07 October 2008 11:37
To: Dx4win-Admin
Subject: [Dx4win] Serial ports


Hello,

I've just installed a dual serial port card into my PC however despite all
my efforts to remove the previously installed virtual USB ports the software
insisted on creating them as Com 9 and 10. Windows insists com 2 - 8 are in
use (only com 1 and 8 actually are) so reasigning the ports doesn't work.

Now for the question Dx4Win only shows com 1 - 8 or at least it does in my
setup so how do I get it to show com9 and 10 in the drop down list box so I
can select them? Do I add them to portmap or is this only for parallel
ports?

I realise a drop down list box that actually lists the installed ports in
the PC would be too simple.

Regards

David


_______________________________________________
Dx4win mailing list
Dx4win at mailman.qth.net
http://mailman.qth.net/mailman/listinfo/dx4win