[Dx4win] Serial ports

[ON4AOI]

Hi David,
Boot in safemode and remove all comports manually (in system setup)
Except if the one that is used for a modem id installed
Don´t attach any USB to serial or Bluetooth or IR devices,
Let windows reboot now and wait until it has installed new found devices
Check the resources of these new comports etc, afterwards you can attach the
USB devices
And check also there settings.

Guy ON4AOI



-----Oorspronkelijk bericht-----
Van: dx4win-bounces at mailman.qth.net [mailto:dx4win-bounces at mailman.qth.net]
Namens David Warr
Verzonden: dinsdag 7 oktober 2008 12:37
Aan: Dx4win-Admin
Onderwerp: [Dx4win] Serial ports

Hello,

I've just installed a dual serial port card into my PC however despite all
my efforts to remove the previously installed virtual USB ports the software
insisted on creating them as Com 9 and 10. Windows insists com 2 - 8 are in
use (only com 1 and 8 actually are) so reasigning the ports doesn't work.

Now for the question Dx4Win only shows com 1 - 8 or at least it does in my
setup so how do I get it to show com9 and 10 in the drop down list box so I
can select them? Do I add them to portmap or is this only for parallel
ports?

I realise a drop down list box that actually lists the installed ports in
the PC would be too simple.

Regards

David


_______________________________________________
Dx4win mailing list
Dx4win at mailman.qth.net
http://mailman.qth.net/mailman/listinfo/dx4win

No virus found in this incoming message.
Checked by AVG. 
Version: 7.5.524 / Virus Database: 270.7.6/1711 - Release Date: 6/10/2008
17:37