[Dx4win] Label error

[Tom LeClerc W1TJL]

Hi Bill,

I use the Dymo 400 Turbo and get the same error each time I print.
Once I bypass it it prints fine but it would be nice to get it to go
away.  I've always thought it had somthing to do with a Windows
setting but have never found it.  So if you get an answer....

73, Tom W1TJL

On 3/9/07, Bill Salyers <coachsals at hotmail.com> wrote:
> DX4WIN users... I have a minor problem that is most likely operator error, but I am stumped.
>
> I have a new PC that I installed 7.02 on. I merged the ini file from my 7.01 installation and brought the database over. That all is fine
> and is working as it should. However, I tried to print labels to my Dymo 400 (as I had been for the past 8 months) and I get the following:
>
> Warning: Not able to set Custom Paper size.
>
> I have it configured correctly for the width,height, # across etc. and I was set to Expert mode when I did it. I shutdown the
> program and started it up. I also rebooted, just to see if Windows 2000 had something to do with it. (I have the same opsys
> on the old PC) I am able to print to the printer from Word and the Dymo app itself.
>
> Any thoughts would be appreciated.
>
> 73 and GuDx
>
> aj8b => Bill_______________________________________________
> Dx4win mailing list
> Dx4win at mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/dx4win
>


-- 
Tom LeClerc, Amateur Radio Station W1TJL
 (past calls WB1CBY, /VE8,XL8,VO1)

          LeClerc Consulting
         email: w1tjl at arrl.net
        PC/Network Consulting