[Dx4win] Internet / Cluster - Telnet selection setup

[Jim Reisert AD1C]

At 10:59 PM 11/19/2005, M. Fitz wrote:

>Can  I  have  DX4Win save the address use most often for Internet / 
>Telnet connection?  Would  like  to  be able  to have dx4win connect 
>to the cluster on  startup.  I  realize  I would  have  to be dialed 
>up and already connected to the Internet.

Yes, by editing the DX4WIN.TCP file in the DX4WIN "SAVE" directory.

>Oh  and  I noticed if one isn't setup when you click connect, a 
>small box comes up with message -> No connection active. Should I 
>happen to change my mind at this point and click cancel or close, I 
>end up in a loop and have to exit dx4win via task-manager in WinXP. 
>If I click .. say close, I get a box that reads -n exception 
>occurred.  I  click  OK on that error message box and get another 
>box that reads - The destination  address  is  required.  Ilick OK 
>and get the other box back again. This is a loop.

What version of DX4WIN, Mark? This works properly on 7.01

73 - Jim AD1C


-- 
Jim Reisert AD1C, 7 Charlemont Court, North Chelmsford, MA 01863
USA +978-251-9933, <jjreisert at alum.mit.edu>, http://www.ad1c.us