R: [Dx4win] Again: Adding QSOs in real-time

[Tibor M. Blum - IK2SAI]

Sorry guys but i still have the problem.
I'm running a TS2000X controlled by the ARCP software.
(dx4win is not engaged to control the radio being the ARCP much more
versatile than dx4win on this regard)
The band and /or mode change any time I receive a spot via the cluster and
it drive me creazy tring to run the contest or even searching and pounching
on the band. Each time I must check that all is ok. Some time after having
properly set the mode, tring to set the band, receiving a spot I must return
to set again the band.
I am starting to be boried by this problem. Have I missed some point?
Tibor, IK2SAI
 

-----Messaggio originale-----
Da: dx4win-bounces at mailman.qth.net [mailto:dx4win-bounces at mailman.qth.net]
Per conto di Richard Eckman
Inviato: sabato 28 maggio 2005 5.06
A: dx4win at mailman.qth.net
Oggetto: [Dx4win] Again: Adding QSOs in real-time

Steve,
  Thanks for the clarification on this issue. I did some more experimenting 
with the 7.01 demo and you're correct: the band/mode is consistent with the 
rig setting in the "Add real time" mode when connected to the rig and the 
packetcluster is active. I did have to reset the poll rate to something a 
bit faster than 5 sec to get the info to display consistently in a rapid 
manner. My apologies for assuming that this band/mode issue was still as it 
was in 6.04.

Regards,

Rich Eckman
KO4MR 
_______________________________________________
Dx4win mailing list
Dx4win at mailman.qth.net
http://mailman.qth.net/mailman/listinfo/dx4win