[Dx4win] PSK31 support for LPT keying

[Roger Borowski]

Larry, In Ver 6.0x, you have to geo into "Preferences" and "Control" and
switch the configuration from CW to PSK31 PTT and back and forth depending
on the mode you are using at the moment. In Ver. 5.02/03 the PTT keying port
was selectable in the PSK31 window. Now its a real pain to switch between
these modes as it requires you to go into Preferences and control each time
you change modes. I've alerted Paul numerous times about this and hopefully
it will be addressed in the next maintenance release.
73, -=Rog-K9RB=-

----- Original Message ----- 
From: "Larry Gauthier (K8UT)" <K8UT@chartermi.net>
To: <dx4win@mailman.qth.net>
Sent: Sunday, October 26, 2003 6:25 AM
Subject: [Dx4win] PSK31 support for LPT keying


> Due to a shortage of serial ports, I use LPT1 to key CW in DX4WIN. This
> works fine for CW, but when operating in PSK31 mode, the LPT keyed line
does
> not seem to operate. I have gone into the PSK Tx preference window and
> checked the "use CW control" - but the LPT CW line does not work from PSK.
> (the frustrating fact is that PSK keying _does_ work under exactly the
same
> settings from the COM port - but my com ports are dedicated to other
> functions).
>
> Am I doing something wrong here ?
>
> -larry
> K8UT
>
> _______________________________________________
> Dx4win mailing list
> Dx4win@mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/dx4win
>