[DSP-10] DSPx Bad/corrupt bank 0 monitor.

[Alvey Street]

On 19/06/2013 02:50, kd7ts wrote:
>
> Are you using the tools from this link ?
>
> http://www.proaxis.com/~boblark/dsp10_dspx_flashbank1.htm
>
> These are pretty fool proof. It might be that the BANK0 contents are 
> still there. The flash loader will not write to the wrong bank, as it 
> looks at the jumpers before proceeding.
>
Hi Mike. Thanks for the quick reply.  Yes I am using these tools from 
that link. I cannot get past a 'time out' message when trying to load 
flashutlb.  If I connect a serial port 9600 n 1 none to the dspx, and do 
a POR, there is no message sent from the DSPx. Also the LED flash is 
wrong.  no flash just one LED on at full brightness.
I was hoping my appeal may have resulted in an offer to loan me, or sell 
me a programmed flash chip, or an offer to put a copy of the monitor 
into my flashchip. Obviously this will not be for free.
I note that lyle Johnson's KK7P website has changed into a finantial 
services site, so I have no easy way of contacting him: unless you know 
differently.
Thanks anyway for the advice.

Regards        Alvey Street   G4KSY