[DSP-10] PC to DSPX communications problem

[Giuliano]

Dear Jimmy,
thanks for your help but I think that you use UHF3X loaded on the RAM area, 
instead I am using UHF3XH loaded in the Flash area so I don't need to load 
the UHF3X.exe any time  because I have DSPx running at power -up. To do this 
I have dowloaded the UHF3XH with FLASHUTIL with the mode  described in the 
KK7P web page
I have others software that are running well in this mode as 17mxcvr ( the 
18MHz trx described in the ARRL book "Experimental Methods in RF Design" ).
So I think that all my hardware is running well ( I have two DSPx boards and 
all are working with 17mxcvr and no with DSP-10) . I think that is an 
incorrect   communications set-up from PC and DSPx ( baud-rate?) but I am 
not able yet to see this set-up inside source file of PC or DSPx program.
Thanks for your help.
many 73 de
Giuliano I0CG
  ----- Original Message ----- 
  From: Jimmy Oldaker W7CQ
  To: giulianori at virgilio.it
  Sent: Friday, October 05, 2007 5:41 AM
  Subject: Re: [DSP-10] PC to DSPX communications problem


  Giuliano I0CG

  I have and Idea.  There have been several running changes and I don't know 
where you are along the path.
  I run mine several different ways depending on which version I have.

  *************************************************************************************
  FOR Com 2
  From a bat file: called DEZLD dot BAT
  TIME
  SET TZ=GMT0
  EZLD 2 UHF3X.EXE G
  UHFA 2

  This requires the program EZLD dot COM which is a modified version of 
EZFAST dot COM

  ************************************************************
  For Com 1
  I also use a D1EZ dot Bat for COM 1

  TIME
  SET TZ=GMT0
  EZFAST 1 UHF3X.EXE G
  UHFA 1

  This requires the program EZFAST dot COM

  *********************************************************************

  The com port is chosen in the bat file and can easily be changed from 1 or 
2 by replacing the 1 with a 2 in the bat file.  I sent you different com 
ports just to show the changes.
  There is a problem with EZFAST on  the latest version of the DSPX loading 
so EZLD was written to take care of this problem.  I don't know what you 
have so one or the other should work.
  Also Hermann F5VKQ was correct in his changing of the config file.
  My config  file is set up that way.
  *************************************************************************

  I placed both versions in my DSP Directory

  D1EZ dot Bat
  DEZLD dot BAT
  EZLD dot COM
  EZFAST dot COM
  UHF3X dot EXE
  UHFA dot CFG
  along with other necessary files in the DSP directory

  I can send you any of the above files in ZIP form if you need them and 
will also be glad to send you my UHFA dot CFG if you think that will help.

  I hope this all makes sense to you.

  Jimmy W7CQ


  This works on my DSPx.