[DSP-10] transverter settings in configuration file

[ww2r at mgef.org]

I have used one of these boxes with my dsp10

as far as the dsp10 is concerned it is a single conversion box with a
288MHz local oscillator when running it in the 432/144MHz mode

dave

ww2r



> Well,  I got a 432 to 2 meter transverter to use with the dsp-10.  It's a
> Microwave modules unit.  An examination of the interior leads me to
> believe
> its a dual conversion box  432 to 28 mhz and back up to 144 mhz. (116mhz,
> 101.0 and 101.5 mhz crystals inside and high / low switch on the outside )
> It generates 144 = 432 on the low switch setting and 144 = 434 with the
> high
> switch setting.
>
> Anyway,  I am clueless as to what changes to make to the configuration
> file
> to make it work!  Gains and frequency range are just fine with the stock
> dsp-10.  I just want to change the frequency display to indicate 432 mhz
> when the unit is actually on 144.
>
> Later, I want to try to correct a 5 khz low output in conversion with the
> software if possible.
>
> What is the proper syntax for the TVTR line in the file?
>
> Thanks
> Joe WA3OTI
>
>
> _______________________________________________
> DSP-10 mailing list
> DSP-10 at mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/dsp-10
>