[DSP-10] transverter settings in configuration file

[Joe C]

Well,  I got a 432 to 2 meter transverter to use with the dsp-10.  It's a 
Microwave modules unit.  An examination of the interior leads me to believe 
its a dual conversion box  432 to 28 mhz and back up to 144 mhz. (116mhz, 
101.0 and 101.5 mhz crystals inside and high / low switch on the outside ) 
It generates 144 = 432 on the low switch setting and 144 = 434 with the high 
switch setting.

Anyway,  I am clueless as to what changes to make to the configuration file 
to make it work!  Gains and frequency range are just fine with the stock 
dsp-10.  I just want to change the frequency display to indicate 432 mhz 
when the unit is actually on 144.

Later, I want to try to correct a 5 khz low output in conversion with the 
software if possible.

What is the proper syntax for the TVTR line in the file?

Thanks
Joe WA3OTI