[DSP-10]

[k7nq-2 at att.net]

Ron,
Sorry, I was looking at Jiro San's pictures. To early in the AM at this Qth HI.  In removing the IC I would wick the solder off the pins then very carefully heat each pin and gently lift pin up using a very pointed and sharp EXACTO knife blade.  I almost made that mistake on that same IC but thanks to KD7 TS I got it on correctly.  Good luck.

Jimmy K7NQ


I
-------------- Original message from Ron Meiring <rmeiring at iinet.net.au>: -------------- 


> Hello Jiro San, 
> 
> I have a DSP10 here, but am not sure about where pin 1 is on U6 
> and on U110. 
> 
> Normally an IC has a point or something to indicate where pin 1 is 
> situated. I got my package from Tapr and can't work out where pin 1 
> is. 
> 
> At least I am not 100 percent sure. 
> 
> Could you please show me how these IC's are mounted. 
> 
> Kind regards 
> Ron VK6KDD 
> 
> 
> >http://mailman.qth.net/mailman/listinfo/dsp-10 
> > 
> > 
> 
> 
> 
> _______________________________________________ 
> DSP-10 mailing list 
> DSP-10 at mailman.qth.net 
> http://mailman.qth.net/mailman/listinfo/dsp-10