[DSP-10] EMRFD 17 m trncvr

[dsp-10 at mailman.qth.net]

Hi Bob,

Thank you for giving the code to Lyle so that he could post it.

I have built a DSP-10 and it was an enjoyable experience having it work,
now would like to experiment with a design similar to the R2 Pro direct
conversion phasing receiver. I do not want to use op amp analog all pass
filters to do the audio phasing so your code loaded into the DSP engine
should do the trick.

I noticed that there are several files, could you please provide a short
description ? Am not familiar with how to load the code into the DSP.

I have built several analog direct conversion receivers with good results
they all have there quirks but can be tamed , Good shielding and power
supply RF bypassing and isolation is mandatory.

I am also going to Dayton on a bus trip with the NJ chapter of the NA DX
association. Perhaps will see you there.

Have a safe trip and enjoyable time in the US

73,

Bob Johansen WB2SRF