[DSP-10] Need Help!

Thu, 18 Mar 2004 12:00:11 -0800

Hi All,

When I built my DSP10 I added a couple of extra feed thus and brought the

reset and LED lines out to the front panel.  I always hate to turn power
OFF
on anything, I guess it comes from being brought on Vacuum Tubes! Anyway
it's very handy.

As soon as I get the DSP 10 back on line, I will be ready to do EME on
10GHz.
I now have the 10 foot dish back in operation and ready to go.

73,  Chuck    WA6EXV

On Wed, 17 Mar 2004 19:58:04 -0800 kd7ts <[email protected]> writes:
> Much to my later regret, I built my DSP-10 without a power switch and 
> no way to
> access the reset button on the ADSP board. If you need (want) to 
> load the ADSP
> with UHF3.exe, the board needs to be reset either by the reset 
> button, or by
> cycling the power off, then back on. The board indicates its 
> willingness to
> accept programming by a slow blinking of the red LED, ALSO INVISIBLE 
> on my RF
> tight enclosure, near the inaccessible reset button. 
> 
> I turn off the DSP-10 by pulling the power plug. It resets when 
> power is
> restored. 
> 
> If you are still running the Analog Devices PROM, there is some 
> annoying music
> and a female voice announcing a willingness to do something.
> 
> If you get the announcement, it is likely the reset has been 
> accomplished.
> 
> If a UHF3 load is unsuccessful, be sure to reset before trying to 
> load again.
> 
> Mike KD7TS
> _______________________________________________
> DSP-10 mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/dsp-10
> 
> 