[DSP-10] Need Help!

[Chuck E. Swedblom]

Hi,

My DSP-10 has been performing perfectly for the past 6 months until
today.

I down loaded the new updated files to give them a try.  When I tried to
start the PC program after the DSP had loaded, I get the following error:
 "Time out error obtaining DSP pointer table.  Either UHF3.exe is prior
to 2.0 or DSP is not responding".  I tried this routine several times and
got the same error message.  I then reloaded the original program and
came up with the same error.

At this point I felt that there was a problem with the DSP-10, so I ran
the two diagnostics programs and they indicated that everything was OK.
The Voltages on both U107 & U108 were correct and the two PLL's were
locked up.  I then retried the original program again, but still got the
error.

The only thing that I noticed when I loaded the original or new operating
programs was that the LED1 had a weak glow.  I do not recall that I ever
noticed this before.

Thank you for any help in this matter.

73,  Chuck   WA6EXV